Yaesu FTDX-3000

General
• RX Frequency Range: 30 kHz – 56 MHz (operating)
1.8 MHz – 54 MHz (specified performance, Amateur bands only)
• TX Frequency Ranges: 1.8 MHz – 54 MHz (Amateur bands only)
• Frequency Stability: ±0.5 ppm (after 1 minute @+14 °F to +122 °F [–10 °C to +50 °C])
• Operating Temperature Range: +14 °F to +122 °F (–10 °C to +50 °C)
• Emission Modes: A1A (CW), A3E (AM), J3E (LSB, USB), F3E (FM), F1B (RTTY), F1D (PACKET),
F2D (PACKET).
• Frequency Steps: 1/10 Hz (SSB, CW, & AM), 100 Hz (FM)
• Antenna Impedance: 50 Ohms, unbalanced
16.7 – 150 Ohms, unbalanced (1.8 – 29.7 MHz)
25 – 100 Ohms, unbalanced (50 – 54 MHz)
(Tuner ON, 1.8 MHz – 50 MHz Amateur bands, TX only)
• Power Consumption (Approx.): RX (no signal) 1.8
RX (signal present) 2.1 A
TX (100 W) 23 A
• Supply Voltage : DC 13.8 V ± 10% (Negative Ground)
• Dimensions (WxHxD): 365 x 115 x 312 mm (36,5cmX11,5cmX31,2cm)
• Weight (Approx.): 22.0 lbs (10 kg)

Transmitter
• Power Output: 5 – 100 watts (2 – 25 watts AM carrier)
• Modulation Types: J3E (SSB): Balanced,
A3E (AM): Low-Level (Early Stage),
F3E (FM) : Variable Reactance
• Maximum FM Deviation: ±5.0 kHz/ ±2.5 kHz
• Harmonic Radiation: Better than -60 dB (1.8 MHz – 29.7 MHz Amateur bands: Harmonic
Better than -50 dB (1.8 MHz – 29.7 MHz Amateur bands: Others)
Better than -65 dB (50 MHz Amateur band)
• SSB Carrier Suppression: At least 60 dB below peak output
• Undesired Sideband Suppression: At least 60 dB below peak output
• 3rd-order IMD: –31 dB @14 MHz 100 watts PEP
• Bandwidth: 3 kHz (LSB/USB), 500 Hz (CW), 6 kHz (AM), 16 kHz (FM)
• Audio Response (SSB): Not more than -6 dB from 300 to 2700 Hz
• Microphone Impedance: 600 Ohms (200 to 10k Ohms)

Receiver
• Circuit Type: Double-conversion Superheterodyne
• Intermediate Frequencies: 9.000 MHz/ 30 kHz (24 kHz for AM/FM)
• Sensitivity: SSB (BW: 2.4 kHz, 10 dB S+N/N)
4 μV (0.5 – 1.8 MHz) (IPO “ON”)
0.16 μV (1.8 – 30 MHz) (RF AMP 2 “ON”)
0.125 μV (50 – 54 MHz) (RF AMP 2 “ON”)
AM (BW: 6 kHz, 10 dB S+N/N, 30 % modulation @400 Hz)
28 μV (0.5 – 1.8 MHz) (IPO “ON”)
2 μV (1.8 – 30 MHz) (RF AMP 2 “ON”)
1 μV (50 – 54 MHz) (RF AMP 2 “ON”)
FM (BW: 15 kHz, 12 dB SINAD)
0.5 μV (28 – 30 MHz) (RF AMP 2 “ON”)
0.35 μV (50 – 54 MHz) (RF AMP 2 “ON”)
There is no specification for frequency ranges not listed.
• Selectivity (WIDTH: Center) Mode -6 dB -60 dB
CW/RTTY/PKT 0.5 kHz or better 750 Hz or less
SSB 2.4 kHz or better 3.6 kHz or less
AM 6 kHz or better 15 kHz or less
FM 15 kHz or better 25 kHz or less
• Image Rejection: 70 dB or better (1.8 MHz – 30MHz Amateur bands)
60 dB or better (50 – 54MHz Amateur band)
• Maximum Audio Output: 2.5 W into 4 Ohms with 10% THD
• Audio Output Impedance: 4 to 8 Ohms (4 Ohms: nominal)
• Conducted Radiation: Less than 4 nWa